G5V-1 - Omron

CSM PCB Con CN J 1 3 - omronfs.omron.com

A-20 最新の商品情報・便利な情報は www.fa.omron.co.jp/ コネクタ 共通の注意事項 コネクタ 共通の注意事項 挿抜作業について ・通電中の挿抜作業時および抜去後に、コネクタの接点 …

  Nomor

CSM XM2 XM3 AC DS J 1 8 - omronfs.omron.com

2 最新の商品情報・便利な情報は www.fa.omron.co.jp/ XM2/XM3 Dサブコネクタ X M 2 ／ X M 3 注1. 1個のコネクタに固定具は2個必要です。 注2. 形XM3K/Lには取付できません。

  Nomor

Solid State Pressure Sensors D8M - omronfs.omron.com

Compact D8M solid state pressure sensors provide reliable detection for gas and air inflow for burner controls in water heaters, furnaces and other gas-fired devices.

  States, Solid, Sensor, Solid state

G5V-2 - omronfs.omron.com

2 G5V-2 Low Signal Relay G 5 V-2 Ratings Coil Note 1. The rated current and coil resistance are measured at a coil temperature of 23°C with a tolerance of ±10%. 2.Operating characteristics are measured at a coil temperature of 23°C.

G6B - Omron

3 G6B PCB Power Relay G 6 B Models for Ultrasonically Cleanable Note: When ordering, add the rated coil voltage to the model number. Example: G6B-1114P-US DC5 However, the notation of the coil voltage on the produc t case as well as on the packing will be marked as @@ VDC.

Solid State Relays Common Precautions

2.Inductive Noise Do not wire power lines alongside the input lines. Inductive noise may cause the SSR to malfunction. If inductive noise is imposed on the input terminals of the SSR, use the following cables according to the type of inductive noise, and reduce the noise level to less than the must release voltage of the SSR.

  Power, Noise, Reduces

DC Power Relays

High-voltage, High-current Loads • A compact relay (73 x 36 x 67.2 mm (L x W x H)) capable of switching 400-V 60-A DC loads. (Capable of interrupting 600 A at 300 VDC max.) • The switching section and driving section are gas-injected and hermetically sealed, allowing these compact relays to interrupt high-capacity loads.

  High, Voltage

G7L - Omron

• Miniature size for maximum switching power, particularly for inductive loads. • Flame-resistance materials (UL94V-0-qualifying) used for all insulation material. • Quick-connect, screw, and PCB terminals, and DIN track mounting available. • Conforms to UL, CSA, TUV and meets IEC950. • Safety design with contact gap of 3 mm.

  Maximum, Load

G2RL - Omron

Test conditions: Shock is applied in ±X, ±Y, and ±Z directions three times each with without energizing the relays to check the number of malfunctions. Requirement: None malfuction 100 m/s2 Sample: G2RL-24 12 VDC Number of relays: 5 pcs Test conditions: Shock is applied in ±X, ±Y, and ±Z directions three times each with without energizing

  Tests

G6S - Omron

Electrical 100,000 operations min. for AC (at 1,800 operations/h with rated load) 100,000 operations min. for DC (at 1,200 operations/h with rated load) Failure rate (P level) (reference value) *3 10 μA at 10 m VDC Ambient operating temperature-40°C to 85°C (with no icing or condensation), and -40°C to 70°C (with no icing or condensation)

  Electrical

Small Signal Fast Switching Diode - Vishay Intertechnology

IF = 100 mA VF 1.2 V Leakage current VR = 20 V IR 25 nA VR = 75 V IR 5 VR = 100 V IR 100 μA VR = 20 V, Tj = 150 °C IR 50 Diode capacitance VF = VR = 0 V CD 4pF Voltage rise when switching ON Tested with 50 mA pulses, tp = 0.1 μs, rise time < 30 ns, fp = (5 to 100) kHz Vfr 2.5 V Reverse recovery time IF = 10 mA, iR = 1 mA, VR = 6 V, RL = 100 ...

  Vishay, Vishay intertechnology, Intertechnology

Data Sheet ADP7142 - Analog Devices

Oct 18, 2021 · Low shutdown current: 1.8 μA at VIN = 6 V, 3.0 μA at VIN = 40 V Stable with a small 2.2 µF ceramic output capacitor Fixed output voltage options: 1.8 V, 2.5 V, 3.3 V, 3.8 V, and 5.0 V 15 standard voltages between 1.2 V and 5.0 V are available Adjustable output from 1.2 V to VIN – VDO, output can be adjusted above initial set point

  Devices, Analog devices, Analog

XA CONNECTOR XA CONNECTOR

Note: 1. The above figure is the figure viewed from the connector mounting side . 2. Tolerances are non-cumulative: ±0.05 mm for all centers. 3. Hole dimensions differ according to the type of PC board and piercing method. The dimensions above should serve as a guideline. Contact JST for details. 1 PC board layout and Assembly layout

Zener Diodes - Vishay Intertechnology

BZX85-Series www.vishay.com Vishay Semiconductors Rev. 2.4, 25-Nov-2021 1 Document Number: 85607 For technical questions within your region: DiodesAmericas@vishay.com, DiodesAsia@vishay.com, DiodesEurope@vishay.com

  Vishay, Vishay intertechnology, Intertechnology

MMBZ5221BLT1 - Zener Voltage Regulators - ON …

mmbz5268blt1g 81u 77.90 82 86.10 1.5 330 2000 0.25 0.1 62 MMBZ5270BLT1G 81W 86.45 91 95.55 1.4 400 2300 0.25 0.1 69 Product parametric performance is indicated in the Electrical Characteristics for the listed test conditions, unless otherwise noted.

LTC1922-1 Modulated Full-Bridge Controller

LTC1922-1 2 SYMBOL PARAMETER CONDITIONS MIN TYP MAX UNITS Input Supply UVLO Undervoltage Lockout Measured on VCC 10.25 10.7 V UVHY UVLO Hysteresis Measured on VCC 3.8 4.2 V ICCST Start-Up Current VCC = VUVLO – 0.3V 145 250 µA ICCRN Operating Current 47 mA VSHUNT Shunt Regulator Voltage Current Into VCC = 10mA 10.2 10.8 V …