ENC28J60 Data Sheet - Microchip Technology
Oct 26, 2012 · with an industry standard Serial Peripheral Interface (SPI). It is designed to serve as an Ethernet network interface for any controller equipped with SPI. The ENC28J60 meets all of the IEEE 802.3 specifica-tions. It incorporates a number of packet filtering schemes to limit incoming packets. It also provides an
Tags:
Serial, Interface, Peripheral, Serial peripheral interface
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
Advertisement
Documents from same domain
Using SAM-BA for Linux on SAMA5D3 Xplained
ww1.microchip.comAN-8995 – Using SAM-BA for Linux on SAMA5D3 Xplained: 42328A−06/2014 Page 5 of 19 2. Setup With Ubuntu distributions, a user has to be member of the dialout group to access serial devices like
Power Factor Correction in Power Conversion …
ww1.microchip.com© 2007 Microchip Technology Inc. DS01106A-page 2 AN1106 FIGURE 1: CURRENT WAVEFORMS WITH AND WITHOUT PFC These waveforms illustrate that …
Power, Factors, Correction, Power factor correction in power conversion, Conversion
2.7V to 5.5V Single Supply CMOS Op Amp
ww1.microchip.comMCP601/1R/2/3/4 DS21314G-page 2 © 2007 Microchip Technology Inc. 1.0 ELECTRICAL CHARACTERISTICS Absolute Maximum Ratings † VDD –VSS.....7.0V
Data Encryption Routines for PIC24 and dsPIC Device
ww1.microchip.com© 2006 Microchip Technology Inc. DS01044A-page 1 AN1044 INTRODUCTION Currently, there are three data encryption standards approved …
Data, Routines, Data encryption, Encryption, Data encryption routines for pic24 and, Pic24
MCP6021/1R/2/3/4 - Rail-to-Rail Input/Output, 10 …
ww1.microchip.com2001-2017 Microchip Technology Inc. DS20001685E-page 1 MCP6021/1R/2/3/4 Features • Rail-to-Rail Input/Output • Wide Bandwidth: 10 MHz (typical)
Low Quiescent Current LDO - Microchip Technology
ww1.microchip.com2005-2016 Microchip Technology Inc. DS20001826D-page 1 MCP1700 Features: • 1.6 µA Typical Quiescent Current • Input Operating Voltage Range: 2.3V to 6.0V
MCP1703 250 mA, 16V, Low Quiescent Current
ww1.microchip.com2010 Microchip Technology Inc. DS22049E-page 1 MCP1703 Features: • 2.0 µA Typical Quiescent Current • Input Operating Voltage Range: 2.7V to16.0V
MTCH6102 Low-Power Projected Capacitive Touch …
ww1.microchip.com2014 Microchip Technology Inc. DS40001750A-page 1 Description: Microchip’s MTCH6102 is a turnkey projected capacitive touch controller that simplifies adding
Controller, Touch, Capacitive, Projected capacitive touch, Projected, Projected capacitive touch controller
PIC32 GUI Development Board with Projected …
ww1.microchip.comPIC32 GUI Development Board with Projected Capacitance (PCAP) Touch Information Sheet Microchip Technology Inc.
Development, With, Board, Projected, Gui development board with projected, Gui development board with projected capacitance, Capacitance
RN4020 Bluetooth Low Energy Module User’s Guide
ww1.microchip.comRN4020 BLUETOOTH LOW ENERGY MODULE USER’S GUIDE 2014 Microchip Technology Inc. DS70005191B-page 7 Preface INTRODUCTION This chapter contains general information that will be useful to know before using the
Guide, User, Energy, Module, Rn4020 bluetooth low energy module user s guide, Rn4020, Bluetooth
Related documents
ESP8266 Technical Reference - Espressif
www.espressif.com2016.06 V1.1 Added Section 4.5 Interface Description. 2016.08 V1.2 Updated Section 14.1 Sniffer Introduction. 2017.05 V1.3 Updated Section 4.1.2 SPI Features. 2019.08 V1.4 Updated Section 1.1 General Purpose Input/Output Interface (GPIO). 2020.07 V1.5 • Updated Section 1.3 Serial Peripheral Interface (SPI/ HSPI); • Added documentation feedback links. ...
Serial, Section, Reference, Technical, Interface, Peripheral, Serial peripheral interface, Technical reference
Low Noise, Low Drift, Low Power, 3-Axis MEMS ...
www.analog.comby their relevant function for either the serial peripheral interface (SPI) or limited I2C interface. 1 Protected by U.S. Patents 8,472,270; ... Changes to Serial Communications Section and Figure 64 ..... 26 Added SPI Bus Sharing Section and Figure 65; Renumbered ... Changes to Temperature Data Registers Section, Table 23, Table 24, and Table ...
Serial, Section, Interface, Peripheral, Serial peripheral interface
SPI Block Guide V4 - NXP
www.nxp.comSPI Serial Parallel Interface SS Slave Select SCK Serial Clock ... SPI Block Guide V04.01 13 Section 1 Introduction ... The SPI module allows a duplex, synchronous, serial communication between the MCU and peripheral devices. Software can poll the SPI status flags or the SPI operation can be interrupt driven. SPI Control Register 1
ATtiny202/204/402/404/406 - Microchip Technology
ww1.microchip.com– One host/client Serial Peripheral Interface (SPI) – One Two-Wire Interface (TWI) with dual address match • Philips I2C compatible • Standard mode (Sm, 100 kHz) • Fast mode (Fm, 400 kHz) • Fast mode plus (Fm+, 1 MHz) – One Analog Comparator (AC) with a low propagation delay – One 10-bit 115 ksps Analog-to-Digital Converter (ADC)
Serial, Interface, Peripheral, Serial peripheral interface, Attiny202 204 402 404 406, Attiny202
Preliminary Product Specification v1 - SparkFun Electronics
www.sparkfun.comYou can operate and configure the nRF24L01+ through a Serial Peripheral Interface (SPI). The register map, which is accessible through the SPI, contains all configuration registers in the nRF24L01+ and is accessible in all operation modes of the chip. The embedded baseband protocol engine (Enhanced ShockBurst™) is based on packet communication
Serial, Electronic, Interface, Peripheral, Serial peripheral interface, Nrf24l01, Sparkfun, Sparkfun electronics
MFRC522 Standard performance MIFARE and NTAG frontend …
www.nxp.comSPI up to 10 Mbit/s I2C-bus interface up to 400 kBd in Fast mode, up to 3400 kBd in High-speed mode RS232 Serial UART up to 1228.8 kBd, with voltage levels dependant on pin voltage supply FIFO buffer handles 64 byte send and receive Flexible interrupt modes Hard reset with low power function Power-down by software mode
Si4463-61-60-C Rev-C High-Performance, Low-Current …
www.silabs.comSi4463/61/60-C 6 Rev 1.0 Table 3. Receiver AC Electrical Characteristics1,2 Parameter Symbol Test Condition Min Typ Max Unit RX Frequency Range FRX 850 — 1050 MHz 350 — 525 MHz