Transcription of LED Lights 04-new - NTE Electronics, Inc
1 16 NTE Electronics, Inc. Voice (973) 748 5089 FAX (973) 748 6224 LightsAutomatic Smart Solar & SensorLED Wall LightFeatures8 High Brightness 2835 LEDs on the FrontAutomatic Night light Feature 2 LEDs on the Rear of the Unit100% Energy SavingPIR Sensor for Full light Brightness Automatic ON/OFFW aterproof (IP65) for Outdoor UseCharged from SunlightNo Wiring NeededTypical Applications Include: Balconies, Decks, Stairs, GardenSheds, Garages, Walls, Porches, Pavilions, Out Building,Entrances, and All Areas that Do Not have Access to Electricity,but have Available SunlightSpecificationsSolar Panel: Monocrystalline SiliconBattery Capacity: , 1200mAhCharging Time: 6 Hours (Full Sunlight)Sensing Range: 2 6 MetersOperating Temperature: 20 to +55 CInduction Angle / Distance: 120 / 6 20 FeetInduction Delay Time: 10 secMounting Height: 6 20 FeetMaterial: PBTI nstallation Instructions1. Drill (2) 6mm holes in the desired place, keeping a118mm distancebetween the 2 holes.
2 Install the lamp at a 2 4 meter height to ensurepeople are in the sensor inductive Place two wall anchors into the Insert a screw in the lower anchor but DO NOT tighten. Insert ascrew into the lower groove. Straighten the entire unit and tightenthe upper screw before tightening the lower : Over tightening of screws may damage the This lamp must be installed where it will be exposed to direct Switch on the lamp by gently inserting the unlock pin into the switchhole just to the right of the PIR sensor. Then, position the solar paneltowards the sunlight. The lamp will turn on to full brightness and theneither stay on or turn off, depending on the ambient InformationNTE Type ColorCCTL uminous Flux(Lm)69 LL 10 White (Front) / Black (Rear)6000K (Front) / 3000K (Rear) ( ) ( ) ( )
