Transcription of UNISONIC TECHNOLOGIES CO., LTD
1 UNISONIC TECHNOLOGIES CO., LTD MC4580 LINEAR INTEGRATED CIRCUIT 1 of 7 Copyright 2017 UNISONIC TECHNOLOGIES Co., Ltd DUAL OPERATIONAL AMPLIFIER DESCRIPTION The UTC MC4580 is the dual operational amplifier, specially designed for improving the tone control, which is most suitable for the audio application. Featuring noiseless, higher gain bandwidth, high output current and low distortion ratio, and it is most suitable not only for acoustic electronic parts of audio pre-amp and active filter, but also for the industrial measurement tools.
2 It is also suitable for the head phone amp at higher output current, and further more, it can be applied for the handy type set operational amplifier of general purpose in application of low voltage single supply type which is properly biased of the input low voltage source. FEATURES *Operating voltage ( 2V ~ 18V) *Low input noise voltage ( Vrms typ.) *Wide gain bandwidth product (15 MHz typ.) *Low distortion ( typ.) *Slew rate (5V/ s typ.) *Bipolar technology ORDERING INFORMATION Ordering Number Lead Free Halogen Free Package Packing MC4580L-D08-T MC4580G-D08-T DIP-8 Tube MC4580L-G08-T MC4580G-G08-T SIP-8 Tube MC4580L-S08-R MC4580G-S08-R SOP-8 Tape Reel MC4580L-P08-R MC4580G-P08-R
3 TSSOP-8 Tape Reel MC4580L-SM1-R MC4580G-SM1-R MSOP-8 Tape Reel MC4580L-K08-2030-R MC4580G-K08-2030-R DFN2030-8 Tape Reel MC4580 LINEAR INTEGRATED CIRCUIT UNISONIC TECHNOLOGIES CO., LTD 2 of 7 MARKING PACKAGE MARKING DIP-8 UTCMC458023415678 Date CodeL: Lead FreeG: Halogen FreeLot Code SIP-8 SOP-8 MSOP-8 TSSOP-8 DFN2030-8 MC4580 LINEAR INTEGRATED CIRCUIT UNISONIC TECHNOLOGIES CO.
4 , LTD 3 of 7 PIN CONFIGURATION OUT1IN1(-)IN1(+)VCC-IN2(+)IN2(-)OUT2 VCC+ TEST CIRCUIT MC4580 LINEAR INTEGRATED CIRCUIT UNISONIC TECHNOLOGIES CO., LTD 4 of 7 ABSOLUTE MAXIMUM RATINGS (TA=25 C) PARAMETER SYMBOLRATINGS UNIT Supply Voltage V+/V- 18 V Input Voltage VIN 15 V Differential Input Voltage VI(DIFF)
5 30 V Output Current IOUT 50 mA DIP-8 SIP-8 750 SOP-8 440 TSSOP-8 360 MSOP-8 300 Power Dissipation DFN2030-8PD 1300 mW Junction Temperature TJ +125 C Operating Temperature TOPR -40 ~ +85 C Storage Temperature TSTG -40 ~ +125 C Note Absolute maximum ratings are those values beyond which the device could be permanently damaged.
6 Absolute maximum ratings are stress ratings only and functional device operation is not implied. ELECTRICAL CHARACTERISTICS (V+ /V-= 15V, TA=25 C) PARAMETER SYMBOLTEST CONDITION MIN TYP MAXUNITI nput Offset Voltage VI(OFF)RS 10k 3 mVInput Offset Current II(OFF) 5 200nA Input Bias Current II(BIAS) 100 500nA Large Signal Voltage Gain Gv VOUT= 10V, RL 2k 90 110 dB Output Voltage Swing VOM RL 2k 12 V Input Common Mode Voltage VI(CM)
7 12 V Common Mode Rejection Ratio CMRRRS 10k 80 110 dB Supply Voltage Rejection Ratio SVR Rs 10k 80 110 dB Operating Current ICC 6 9 mASlew Rate SR RL 2k 5 V/ sGain bandwidth Product GB f=10 KHz 15 MHzTotal Harmonic Distortion THD Gv=20dB,VOUT=5V,RL=2k , f=1 KHz % Input Noise Voltage eN RIAA Rs= k , 30kHzLPF Vrms MC4580 LINEAR INTEGRATED CIRCUIT UNISONIC TECHNOLOGIES CO.
8 , LTD 5 of 7 TYPICAL CHARACTERISTICS )HznV( MC4580 LINEAR INTEGRATED CIRCUIT UNISONIC TECHNOLOGIES CO., LTD 6 of 7 TYPICAL CHARACTERISTICS(Cont.) MC4580 LINEAR INTEGRATED CIRCUIT UNISONIC TECHNOLOGIES CO., LTD 7 of 7 UTC assumes no responsibility for equipment failures that result from using products at values thatexceed, even momentarily, rated values (such as maximum ratings, operating condition ranges, orother parameters) listed in products specifications of any and all UTC products described or containedherein.
9 UTC products are not designed for use in life support appliances, devices or systems wheremalfunction of these products can be reasonably expected to result in personal injury. Reproduction inwhole or in part is prohibited without the prior written consent of the copyright owner. The informationpresented in this document does not form part of any quotation or contract, is believed to be accurateand reliable and may be changed without notice.
