Transcription of 3109 - PR electronics
1 Isolated converter / splitter3109 Isolation and conversion of standard DC signals Slimline housing of 6 mm Power supply and signal isolator for 2-wire transmitter Splitter function: 1 in - 2 out DIP-switch configured ApplicationsApplicationIsolation and conversion of standard DC signals. Galvanic separation of analog current and voltage signals. Elimination of ground loops and measurement of floatingsignals. A competitive choice in terms of both price and technology forgalvanic isolation of current and voltage signals to SCADA systems or PLC equipment.
2 Installation in ATEX Ex zone 2 / IECEx zone 2 / FM division 2. Suitable for environments with high vibration stress, Technical characteristicsEasy configuration via DIP-switches. The input is protected against overvoltage and polarity error. Factory-calibrated measurement ranges. Inputs and outputs are floating and galvanically separated. This page is automatically generated on the basis of information provided on and affiliated websites. It is provided to you as a service and for informationpurpose only.
3 While we have attempted to maintain the information as accurately as possible, the page may contain errors or omissions for which we disclaim any and all liability3109-082318 Environmental ConditionsOperating C to +70 CStorage C to +85 CCalibration CRelative < 95% RH (non-cond.)Protection degree 2 &measurement / overvoltagecat. IIMechanical specificationsDimensions (HxWxD)..113 x x 115 mmWeight gDIN rail EN 60715/35 mmWire x mm2 / AWG wireScrew terminal 4 gCommon specificationsSupplySupply VDCMax.
4 Required WMax. power WIsolation voltageIsolation voltage, test kVAC / 300 VAC(reinforced)Zone 2 / Div. VACR esponse timeResponse time ( , )..< 7 / noise > 60 dBCut-off frequency (3 dB)..> 100 HzSignal dynamics, signal chainSignal dynamics, signal than of selectedrangeTemperature < of span / CEMC immunity < of spanExtended EMC immunity: NAMURNE21, A criterion, < 1% of spanInput specificationsCurrent inputMeasurement mAProgrammable measurement and mAInput voltage < VDCV oltage inputMeasurement VProgrammable measurement and 0 VMeasurement V / VInput 500 k 2-wire transmitter > 17 V / 20 mAOutput specificationsCurrent outputSignal mAProgrammable signal / mALoad (@ current output).
5 300 Load of span / 100 Current 28 mAVoltage outputSignal VDCP rogrammable signal and 0 VLoad (@ voltage output).. 10 k of of the DIP-switch selectedoutput / Ex 3 G Ex nA IIC T4 nA IIC T4 I, Div. 2, Gp. A, B, C, D T4or Cl. I, Zone 2, AEx nA IIC I, Div. 2, Gp. A, B, C, D T4or Cl. I, Zone 2, Ex nA IIC T4 Observed authority 020/2011 ApprovalsATEX 2014/34 10 ATEX0147 /FM17CA0003 XDNV-GL f. Certific. No. 61010-1 EAC Ex TR-CU 012
