LT1010 - Fast ±150mA Power Buffer - Analog Devices
Slew Rate VS = ±15V, VIN = ±10V, VOUT = ±8V, RL = 100Ω 75 V/µs VSOS + Positive Saturation Offset IOUT = 0 (Note 5) l 1.0 1.1 V V VSOS – Negative Saturation Offset IOUT = 0 (Note 5) l 0.2 0.3 V V RSAT Saturation Resistance IOUT = ±150mA (Note 5) l 22 28 Ω Ω VBIAS Bias Terminal Voltage RBIAS = 20Ω (Note 6) l 700 560 840 880 mV mV IS ...
Tags:
Devices, Rates, Analog devices, Analog, Slew, Slew rate
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
Documents from same domain
AD743 Ultralow Noise BiFET Op Amp Data Sheet …
www.analog.comREV. E Information furnished by Analog Devices is believed to be accurate and reliable. However, no responsibility is assumed by Analog Devices for its
Devices, Noise, Ad743 ultralow noise bifet op amp, Ad743, Ultralow, Bifet, Analog devices, Analog
1.8 V Low Power CMOS Rail-to-Rail Input/Output …
www.analog.com1.8 V Low Power CMOS Rail-to-Rail Input/Output Operational Amplifier Data Sheet AD8515 Rev. E Document Feedback Information furnished by Analog Devices is believed to be accurate and reliable.
Devices, Operational, Data, Input, Analog devices, Analog, Output, Cmos rail, Cmos, Rail, To rail, To rail input output operational amplifier data, Amplifier
Low Cost Micropower, Low Noise CMOS Rail-to …
www.analog.comLow Cost Micropower, Low Noise CMOS Rail-to-Rail, Input/Output Operational Amplifiers Data Sheet AD8613/AD8617/AD8619 Rev. H Document Feedback Information furnished by Analog Devices is believed to be accurate and reliable.
Devices, Operational, Sheet, Data, Input, Analog devices, Analog, Output, Cmos rail, Cmos, Rail, To rail, Amplifier, Micropower, Input output operational amplifiers data sheet ad8613, Ad8613
MT-070: In-Amp Input RFI Protection - Analog …
www.analog.comRev.0, 10/08, WK Page 1 of 6 MT-070 TUTORIAL In-Amp Input RFI Protection . PROTECTING IN-AMPS AGAINST RFI . Real-world applications must deal with an ever increasing amount of radio frequency
LTC3108 - Ultralow Voltage Step-Up Converter and …
www.analog.comLTC3108 3108fc For more information www.linear.com/LTC3108 LDO
Low Cost CMOS, High Speed, Rail-to-Rail Amplifiers
www.analog.comLow Cost CMOS, High Speed, Rail-to-Rail Amplifiers Data Sheet ADA4891-1/ADA4891-2/ADA4891-3/ADA4891-4 Rev. F Document Feedback Information furnished by Analog Devices ...
Zero-Drift, Single-Supply, Rail-to-Rail Input/Output ...
www.analog.comZero-Drift, Single-Supply, Rail-to-Rail Input/Output Operational Amplifier Data Sheet AD8628/AD8629/AD8630 FEATURES Lowest auto-zero amplifier noise Low offset voltage: 1 µV AD8628
Operational, Data, Input, Output, Rail, To rail input output operational amplifier data, Amplifier, To rail input
FEATURES DESCRIPTIO U - analog.com
www.analog.com1 LT1025 1025fb DESCRIPTIO U APPLICATIO S U 80µA Supply Current 4V to 36V Operation 0.5°C Initial Accuracy (A Version) Compatible with Standard Thermocouples (E, J, K, R, S, T) Auxiliary 10mV/°C Output Available in 8-Lead PDIP and SO Packages Thermocouple Cold Junction Compensator Centigrade Thermometer Temperature …
LT1173 - Micropower DC/DC Converter Adjustable …
www.analog.comLT1173 1 Micropower DC/DC Converter Adjustable and Fixed 5V, 12V VOUT 5V/DIV 0V PROGRAM 5V/DIV 5ms/DIV 1173 TA02 L1* 100µH LT1173 • TA01 + GND SW2 FB SW1 ILIM VIN 10 F LT1173
AD9850 CMOS, 125 MHz Complete DDS …
www.analog.comrev. h a cmos, 125 mhz complete dds synthesizer ad9850 functional block diagram clock out clock out analog in analog out dac rset …
Complete, Analog, 125 mhz complete dds, 125 mhz complete dds synthesizer, Synthesizer
Related documents
A CAN Physical Layer Discussion
ww1.microchip.comThe decreased slew rate implies a slower CAN data rate at a given bus length, or a reduced bus length at a given CAN data rate. STANDBY Standby (or sleep) mode is entered by connecting the RS pin to VDD. In sleep mode, the transmitter is switched off and the receiver operates in a reduced power mode. While the receive pin (RXD) is still
Rates, Physical, Early, Discussion, Slew, A can physical layer discussion, Slew rate
NE5534 - Operational Amplifier, Low Noise, Single
www.onsemi.comload, slew rate, low overshoot, etc.). Features • Small-Signal Bandwidth: 10 MHz • Output Drive Capability: 600 , 10 VRMS at VS = 18 V • Input Noise Voltage: 4nV Hz • DC Voltage Gain: 100000 • AC Voltage Gain: 6000 at 10 kHz • Power Bandwidth: 200 kHz • Slew Rate: 13 V/ s • Large Supply Voltage Range: 3.0 to 20 V
NI 6351 Device Specifications - National Instruments
www.ni.comSlew rate 20 V/μs Glitch energy at midscale transition, ±10 V range 10 nV · s External Reference APFI 0 characteristics Input impedance 10 kΩ Coupling DC Protection, device on ±30 V Protection, device off ±15 V Range ±11 V Slew rate 20 V/μs 1 Typical behavior. Time period may be longer due to host system USB performance. Time period
50 µA, 2 mm × 1.7 mm WLCSP, Low Noise, Heart Rate …
www.analog.comSlew Rate . SR : 0.01 . V/µs . Voltage Noise Density (RTI) e. n . f = 1 kHz : 120 . nV/√Hz . Peak-to-Peak Voltage Noise (RTI) e n p-p : f = 0.1 Hz to 10 Hz . 7 . µV p-p . f = 0.5 Hz to 40 Hz . 9 . µV p-p . RIGHT LEG DRIVE AMPLIFIER (A2) Quiescent Supply Current . 7.5 . 10 . µA : Output Swing . R. L = 50 kΩ . 0.1 +V S − 0.1 . V . Short ...
MC33272A - Operational Amplifiers, Single Supply, High ...
www.onsemi.comHigh Slew Rate, Low Input Offset Voltage The MC33272/74 series of monolithic operational amplifiers are quality fabricated with innovative Bipolar design concepts. This dual and quad operational amplifier series incorporates Bipolar inputs along with a patented Zip−R−Trim element for input offset voltage reduction.
Operational Amplifier Circuits - MIT OpenCourseWare
ocw.mit.edureactive elements. Providing we keep the operating conditions out of the slew rate limit then this is a reasonable model. Here we wish to extend this picture of op amp operation to include circuits that are designed to be frequency dependent. This will enable the construction of active filters, integrators, differentiators and oscillators.
R XC2C32A CoolRunner-II CPLD - Xilinx
www.xilinx.comconfigurations include slew rate limit, bus hold, pull-up, open drain, and programmable grounds. A Schmitt trigger input is available on a per input pin basis. In addition to stor-ing macrocell output states, the macrocell registers can be configured as "direct input" registers to …
0 R XC9572XL High Performance CPLD - Xilinx
www.xilinx.com• Slew rate control on individual outputs • Enhanced data security features • Excellent quality and reliability - Endurance exceeding 10,000 program/erase cycles - 20 year data retention - ESD protection exceeding 2,000V • Pin-compatible with 5V-core XC9572 device in the 44-pin PLCC package and the 100-pin TQFP package
MCP4802/4812/4822 Data Sheet - Microchip Technology
ww1.microchip.comSlew Rate SR — 0.55 — V/µs Short Circuit Current ISC —15 24 mA Settling Time t SETTLING — 4.5 — µs Within 1/2 LSb of final value from 1/4 to 3/4 full-scale range Dynamic Performance (Note 2) DAC-to-DAC Crosstalk — <10 — nV-s Major Code Transition Glitch — 45 — nV-s 1 LSb change around major carry